Technical data of lag switch timer (staircase)
ElectroKaveh TIMER LAG SWITCH ( STAIRCASE)
Type: KRTS
Ability : Start measuring the time after connecting the supply voltage Power saving Longevity of lamps Suitable for filament lamps, fluorescents and LEDs Set time of 1 or 6 minutes by the DELAY potentiometer handle
display signals: RED : Output connector relay ( OUT )
GREEN : Power input ( PWR )
Installation and Start-Up: The network phase wire is connected to the terminal PH and the network wire to the MP terminal. All lamps are connected in parallel with the network node on one side and connected to the COM terminal on the other side. All push buttons on one side connect to the PH terminal parallel to each other and connect to the COM terminal on the other side.
Principles of Operation: This device is designed to save energy and extend the life of the lamps. In many apartments and corridors, the installation of a fixed key is not economical in terms of saving electrical energy. Because after turning on the lamps, they should be turned off after a few minutes, which is usually forgotten. Using the KRTS timer, you can turn on the bulbs by pressing a key. After the set time has elapsed, the device automatically turns off the lamps.
After wiring, the PWR signal is turned on by connecting the power supply. Each time you press the push buttons and the OUT signal turns on and after the time setting is completed, the lights and the OUT signal are deactivated by the TIME potentiometer handle.
Technical Specifications: Supply voltages of:
220 V AC ± 10% Network Frequency: 50 Internal Loss: 3 w for 220 v ac Output poewer: 1500 w Environmental conditions: -20 to +60 ° C humidity : 15 to 85 %
Mounting:
In all the directions
Certificate: ISO 9001 : 2008
Standards: IEC/EN 60255-22 IEC/EN 60255-25 IEC/EN 60255-27 ISIR 4221-1 ISIR 4221-21 All other technical specifications available upon request
